|MS Exchange 2007- SMTP Authentication Configuration for Mail Relay Outbound Service|
|To assist our users in using our Mail Relay Outbound service, this document describe the procedures on how to configure MS Exchange 2007 to use SMTP Authentication Configuration to work with the Mail Relay service at DnsExit.com.|
First, you may want to check if your ISP is blocking outgoing SMTP port by use DOS/Unix command:
c:\> telnet relay.dnsexit.com 25
If the port is open, you should see some messages like
Connected to relay.dnsexit.com (126.96.36.199).
If there is no response at port 25, you ISP must have blocked the port. To go around port 25 blocking that is common practice by a lot of ISPs, we have other ports open for your mail relay. You can try port 26, 940, 8001, 2525, 80 by using the same telnet command by telnet to the alternative port instead of 25. If the connection gets responses from the alternative SMTP port, you should use that port instead of 25 when setting up Smart Hosting. Here are the settings using in Exchange 2007
Creating the SMTP Connector :
Deploy Organization Configuration....
On the left pane click on "Hub Transport"
|In the first Screen Type a name for your SMTP Connector (ex: DNSExit Send Connector) and leave Custom in the selection list and click "Next"
In the address space screen press "Add" and type the caracter star in the "Address" field.
Leave 1 in the "Cost" field to make it as primary and press "OK"
|Don't check the "Scoped send connector" option and click "Next".
In the "Network settings screen check" "Route mail trough the following smart hosts:" press "Add".
|In the "Configure smart host authentication settings" screen select "Basic Authentication" and type your DNS Exit login and your password then press "Next".
In the "Source Server" screen press "Add" and add the server where your Exchange is installed press "Next" then press "New".
The SMTP Connector is created, try to send an email, it should be ok. If not restart your server or your "Microsoft Exchange Transport" service.
One time the configuration is done, you can verify your installation with the following captures.